I finally opened up the new 1byone motion sensor I got
The package it came in had two boxes in it
The receiver board looks the same as the bunker hill ones but they are different.
Also the transmitter uses 3 AAA batteries whereas the bunker hill uses a single 9V
I found a a web site mentioning on of the IC chips on board,
That I should use pin 11 on the PT4303 chip to grab a signal.
My soldering skills are good enough, but I really need to add some strain relief some how.
On the workout front, I did really well on a Cedar River 2 mile run
Time: 30:49
Not my fastest, I need to be cracking 30 minutes before I start looking at a personal best.
Finally, on a fun note, I got my Seahawks tickets.
