I have been struggling with this for a while now but seems like I finally figured it out.
I been using gimp to print some diagrams for my arudino kit. I finally figured out why it was not printing right, it is because you have to ignore margins and not center. After I did that an inch was an inch on paper and against the grid when turned on in gimp.
I am staring at my quick build document. I think this is all the information I am going to give, I am going to proof it and double check, but the layout and general info on it is complete.
Got a mild headache, I think it is a dehydration headache, I need to start pumping myself with water again. Family seems beat too, half of us are asleep.
Gonna hit some pushups and situps. I hope to run tomorrow.