Finally was able to print my own stuff. It is a gridfinity base.
After I printed it, I added the magnets, as I post the 4th one is printing.
This was from the SD card though, I sliced it in Orca, then copied it to the SD card. I had to choose the filament from the AMS.
I then put it on the network and upgraded the firmware (yes I did, still LAN OK) and I was able to access it from the LAN.
Had trouble crossing subnets though, but I but of googling and I had to setup the UDP Broadcast Relay on pfsense.
Here is how it looks.
Thanks to this blog post https://nuxx.net/blog/2024/12/19/bambu-lab-p1s-on-iot-vlan/
I am almost there, after it prints I going to add 3 more filament spools.
Weight: 335.6