Got a one of my pi nodes fully built.
One of the things I needed to make were a bunch of plates.
I started with a template but did the 5 I needed all at a time.
After I was done I tested it out with what I got
Another thing I needed were some fasteners
The top left were Philips Pan Head 2-56 1/2″ screws
The section below it contains matching nuts
The top nylon standoffs were some random ones I found around the house, I did not like them. The nylon standoffs below it I did use but had a limited supply, but enough.
https://www.mouser.com/ProductDetail/144-13SP041
The metal and nylon washers are M3 ones that are easy to find.
The top left screws are hard drive screws but found that it is better to use M.3 and were 6mm long. It fit better.
Ran Cedar River 18:08.73
Could be better.
Weight: 317.4