Monthly Archives: June 2018

Highlight of the Weekend

Posted on June 30, 2018 by larry

Wife and I alone at the Casino. Kind of nice to gamble, eat take a nap, repeast We are here at the Angle of the Winds casino, not much here, but it is nice. Wish we were here for two … Continue reading →

Posted in Training | Leave a comment

Made it to Canada

Posted on June 29, 2018 by larry

Finally in Canada, drive was amazing this morning, left at about 5:45AM. Took 1 rest stop break while headed up there. I think we hit the boarder at about 8AM But it was fast crossing the boarder, I do not … Continue reading →

Posted in Training | Leave a comment

Rushing to Leave

Posted on June 28, 2018 by larry

Man schedule all screwed up. Was hoping to be asleep 4 hours ago, hopefully tomorrow when I go on a road trip I will have energy, Otherwise, safer to go in traffic then early and sleepy.  

Posted in Training | Leave a comment

Roku Action

Posted on June 27, 2018 by larry

Pulled the trigger on getting a Roku, should have gotten it first. It seems to work well. I want to do a review on it, but it is running as I post. Not sure how I am going to prevent … Continue reading →

Posted in Technical, Training, Weigh In | Leave a comment

Paid the Price

Posted on June 26, 2018 by larry

Tried to run today, felt ok for an hour or two after. But now, it hurts I think I pushed to hard, tomorrow will try again. Maybe easier.  

Posted in Training | Leave a comment

Power Outage Knocked Out System

Posted on June 25, 2018 by larry

Last night had a power outage, one of my ESXi hosts was rebooted. Need to fix that. But another issue was that an connectivity to the MQTT server was lost for a few minutes.  MQTT server was not down, just … Continue reading →

Posted in Arduino, Technical, Training | Leave a comment

ESP8266 Friendly 315 Mhz TX/RX

Posted on June 24, 2018 by larry

After some trial and error I think I have settled on some 315Mhz Transmitter and Receivers I like The ones in blue are the 315Mhz ones I like. Although I did not get mine from ebay, I found them doing … Continue reading →

Posted in New Toys, Technical, Training | Leave a comment

Friend Lost Weight

Posted on June 23, 2018 by larry

Went to a birthday party of a friend’s grandson. I have not seen him friend for a while and he lost a LOT of weight. He said we was on a Keto diet. It warrants some investigation. Going to look … Continue reading →

Posted in Training | Leave a comment

Got To Count Calories

Posted on June 22, 2018 by larry

Sunday I begin counting calories again, then the following Sunday I will start to enforce calorie counts. I can’t lose weight on the burning side, so I have to lose weight on the intake side. Not much to report today, … Continue reading →

Posted in Training | Leave a comment

New Tool For Virtual Center

Posted on June 21, 2018 by larry

Today I had to query virtual center. I tried the old vmware-vix utility and it just did not work. Then I found a utility called govc, the binary can be downloaded from here https://github.com/vmware/govmomi/releases/download/v0.16.0/govc_linux_amd64.gz It’s a simple gunzip of the … Continue reading →

Posted in Technical, Training, Virtualization | Leave a comment